The engine cooling system performs the following major functions: The main function of the cooling system is to eliminate additional heat from the engine and prevent the engine from overheating. It ensures the normal operating temperature of the engine. It increases the temperature of the cold engine when needed.
HSW The thermostat's main job is to allow the engine to heat up quickly, and then to keep the engine at a constant temperature. It does this by regulating the amount of water that goes through the radiator. At low temperatures, the outlet to the radiator is completely blocked -- all of the coolant is recirculated back through the engine. T10 and T10+ Pro Smart Thermostat with RedLINK® 3.0 Programmable Thermostat Professional Install Guide (English, French, Spanish) Honeywell Home thermostats work with utility programs to reward you for helping save energy. Drill holes at marked positions, and then lightly tap supplied wall anchors into wall using a hammer. The thermostat can fine-tune your room’s temperature by opening and closing furnace connections. This all works thanks to an electrical coil embedded inside that function as a temperature sensor, allowing it to identify any fluctuations in temperature. As the temperature rises beyond your desired setting, the coil will extend and close off RLV4305A is a single pole/2 wire line voltage thermostat from Honeywell, which can operate at two voltage levels – 120 volts/240 volts. This model is 5-2 day programmable, which means you can set two different schedules, one for weekdays and the other for weekends. At 240 volts, a max load of 3500 watts can be handled. Finally, an air bleeder valve is located on the top of the thermostat housing, which allows one to quickly and easily bleed out any trapped air after cooling system maintenance has been performed. Low Operating Pressure: The entire cooling system on the LT1 is designed to operate at lower pressures than conventional cooling systems.The overflow tank holds coolant. When the level in the cooling system gets too low, coolant is withdrawn from the storage to enter the cooling system. On the other hand, if there’s too much pressure, coolant will be pulled from the cooling system back into the overflow tank. Because the cooling system is a closed unit, the amount of coolant8EoI.